RE: Handlebars - 2

Zitat von runnerhiker im Beitrag #15

---

I like the looks of the R bars a lot. I installed HeliBar adjusters to my RS, they raise the bars about 1" and towards the rider about 3/4" and that has worked great for me. My S1000 XR is too upright and I am wondering if I can install the S1000 R bars on it for a sportier stance.
It seems like we are never satisfied, there is always one more adjustment to make.

---

Ergonomics are the most important. Second only to looks. And comfort.

Hi Tony101

Fitting the R bars seems like a workable option for me, how much closer are the R bars to the rider than say fitting bar / back risers?

Cheers
Tony

Zitat von Tony Holmes im Beitrag #19

---

Hi Tony101

Fitting the R bars seems like a workable option for me, how much closer are the R bars to the rider than say fitting bar / back risers?

Cheers
Tony

---

建築用の外径31.8φで厚みが1.6㎜のパイプを切ってスペーサーを作成すれば、Ｒ１２００Ｒのクランプと組み合わせる事で、市販の28φのテーパーハンドルが使えるようになります。
パイプを加工する設備さえあれば、一番安上がりでバーハンドルの選択肢も多いです。

I have the Helibar risers on my RS but find that I would like the bars to be even closer and higher. I've therefore been thinking about installing either the bars from the R1250R or the Wunderlich bars, I've been unable to find out how these two handlebars compare. Wunderlich says their bars are 2.25 inches wider, 2.75 inches higher and 1.25 inches back. Does anyone have the dimensions for the bars from the R1250R?
Its hard to decide what to do without knowing what the dimensions of the 1250R bar are. Any information about this would be appreciated.

Thats not a bad idea but my nearest dealer is around 2.5 hours away. I may go there anyway. My wife used to own an 2017 R1200R, which I rode several times. I liked the handlebar position, but that bike had a lower seat, so it wasn't a direct comparison to my RS with the standard height seat. I guess I can go to the dealer with the seat from my RS and put it on an R.
Unfortunately I won't be able to get there for a couple of weeks, so if anybody has any info on the relative dimensions of the 1200R bars and the Wunderlich bars I would still appreciate hearing about it.
Thanks.

One more thought: I want to reposition my Nav unit to either the Moto Mate mount or the Hornig mount. Any idea if those mounts might interfere with the handlebars from an R1250R?

https://www.onlinemetals.com/buy/stainle...-welded/pid/477

At $35 plus $8 in S&H, I could have two sets! If I wanted to do the suggested adapter.

Although, it's not for me.......it's a great suggestion

I think that's about right. Only major drawback of the BMW bars is the cost $$$$. Wunderlich are not far behind

looking at getting the lsl bars but not sure which clamps i need for my 1250rs

Ja zmieniłem kierownicę na kierownicę GSA i jest naprawdę super. Wymiany wymagał przewód sprzęgła.