Electronics » Canbus Installation

Thought I'd start a new thread for this. I've just gotten a Hex EZCan and while there are good videos out there, they always show a GS. I think I have a handle on where the RDC (tire sensor monitor) is on the RS, but I'm not 100% sure of the connections from the EZ can to the RDC / bike wiring. If anyone has done this, has any pictures, and can help, it would be appreciated.

Hi Immersion suit,
The TPMS (Tyre Pressure Management System) is located under the cross-brace beneath the pillion seat.
The connector is a bit of a bitch to get to and release as the seals are quite strong.
They are easy t ofit and configure, any questions give me a shout.

Thanks for the assist Fugly. Should I be trying to remove the cross-brace or just fingering out the connectors?

The cross brace is a structural part of the subframe so you have no choice but to get under it with your fingers and unlock the latching clip and try to remove the connector.
Please dont try to remove it by pulling on the wires! I bent the end of a small screwdriver so I could get it past the end of the connector body and use it as a lever to slide the connector off the mating half.

I hope that is fairly self explanatory

Thanks fugly. It actually came out pretty easy for me. I was having difficulty figuring out what to do with the plug I pulled out, but re-watching the video game me a lightbulb moment.

Zitat von Immersion Suit im Beitrag #5

---

Thanks fugly. It actually came out pretty easy for me. I was having difficulty figuring out what to do with the plug I pulled out, but re-watching the video game me a lightbulb moment.

---

Over the weekend, I updated the firmware and my laptop talks to the Hex. It's pretty weird hooking a laptop up to a motorcycle. I'm actually stalled on the next bit. I have two wires coming back from the Weiser Teknik 2-in-1 brake turn signal LEDs and three wires on the plug for the Hex. Is one a ground? This kind of stuff is new territory to me.

Hi Immersion Suit,

I understood that the whole point of the Weiser 2 in 1 lights was that they operated without a Hex and gave you hex functionality

My understanding was that the Weiser brake lights won't flash without a canbus controller.