Electronics » LED Spot suggestions

I installed a Hex EzCan on my 2018 R1200RS. I'm happy with with what it does. I also installed GIVI S310 Halogen Spots. Bad bulb half way between Houston and Orlando after only 2100 miles. Changing expensive bulbs every 2000 miles doesn't excite me.

Would like to change the Spots for LEDs. The EzCan uses PWM to control LED lights, so I'm looking for a set of PWM compatible LED spots to replace those GIVI S310 Trekkers. Anybody know of any reasonably priced?

Thanks in advance for any input.

Zitat von colliny im Beitrag #1

---

I installed a Hex EzCan on my 2018 R1200RS. I'm happy with with what it does. I also installed GIVI S310 Halogen Spots. Bad bulb half way between Houston and Orlando after only 2100 miles. Changing expensive bulbs every 2000 miles doesn't excite me.

Would like to change the Spots for LEDs. The EzCan uses PWM to control LED lights, so I'm looking for a set of PWM compatible LED spots to replace those GIVI S310 Trekkers. Anybody know of any reasonably priced?

Thanks in advance for any input.

---

Denali d2's, work off my wonder wheel controller

Also recommend Clearwater’s and Baja Designs

Clearwater Darla and Krista pictured top/bottom.

Zitat von backRoadS im Beitrag #4

---

Also recommend Clearwater’s and Baja Designs

Clearwater Darla and Krista pictured top/bottom.

---

Using the Moro-Mate high mounts from @Fugly. They go thru front winglet blot. Simple and effective for small upper lights. Highly recommended.

So far I’ve tested them for over 3,000 miles and had to tighten a bit (not lose or falling) at 1500. But no biggie and took all of 10 seconds for both sides.

Never heard of them, gonna check 'em out. Controlled via EzCan or similar? Thanks.

Never heard of them, gonna check 'em out. Controlled via EzCan or similar?
Just read their website. Thank you!

Typo Moto-Mate

I have mine controlled by EzCan (4 lights one circuit) yes. Or similar. Clearwater sells their own Version of “can opener.” Works too.