R1200RS + R1250RS Forum
Print view
Fri Apr 30, 2021 10:09 pm
|
I honestly cannot say how long it takes for my gauge to read full after a fill up.
Carpe Diem!
|
|
reply
|
I’ve recently noticed that it’s a lot slower on a top off compared to filling from empty. I think it needs to register the new volume, and the less dramatic the change, the more the software waits to ensure the new “full” indication isn’t a glitch.
I’m a Notary Public. RESPECT MY AUTHORITY!
|
|
|
I find that the time the gauge takes to move after a fill up is variable. Sometimes instant and sometimes as I'm driving away. I have thought 'it's not going to work' a couple of times but it always gets there eventually. |
|
Zitat von Chubs McFun im Beitrag #14 I'm reviving this thread again. My issue is getting worse. I can't remember if I did the hard reset last year, but I expect I'll do that tonight. I need to take the bike in for service to clear the service light and get a tire and my annual inspection (NC). When I discussed the fuel gauge issue with the service department they didn't give an adequate answer about the mechanical aspects of the fuel gauge/float etc. Here's my question, what is inside the tank that actually registers the fuel level? Is there a float? Is there an electrode of some kind? The gentleman at the dealership didn't seem to know. If it is a mechanical float, I assume it just needs a good wiggle and gunk removal so that it can move freely. If it is an electrode or electronic sensor it probably needs to be replaced. Lastly it could be a software/firmware issue which is an entirely different animal. |
|
|
|
there's quite a bit of chatter on UKGSer about wonky fuel strips and even some people on older bikes converting them to a float type
Spam goes here
|
|
Quick update, the fuel gauge came back to life when I started the bike to ride home from the office. I work as a chemist, so as a scientist I must say that the evidence shows that the fix to every issue it to post to this forum and let magic happen. |
|
|
My 1200GS had the fuel sensor strip problem at about 5 years age. The only solution was a new strip fitted. |
|
|
Reviving the thread one more time. Does anyone have the BMW Part Number for the fuel level sensor? It is electronic and the dealer wanted around $250 for part. |
|
Zitat von Chubs McFun im Beitrag #23 Fuel level sensor for R1200RS Part # 16 14 8 568 699 SET: LEVER SENSOR (to 07/16) 0.11 1 $184.46 The prices on the Max BMW parts fiche are not always up to date. A&S BMW shows $195 Lee |
|
Zitat von Mr. 36654 im Beitrag #25 I see the old Capitol Cycle is offering an aftermarket (Enduralast) replacement for $230. Sadly, that's more than the BMW part.
Old Forum Orphan
|
|
