General topics » Quad Lock Mount

Hello folks, long time no see.
Unfortunately, I'm no longer a commuter, as Covid has seen my office shut down, and I'm now officially a home worker. My last couple of tours also got cancelled, and so I'm lucky if I get out once every two weeks for a ride. Bah!

Anyway, I *do* have a tour coming up (Yay!), and want to have my phone handy, but also leave my BMW Navigator in place. I have a Quad Lock case for my phone, and a mount on my wife's bike, which I'm going to borrow, but I can't quite figure where I'm going to put the thing on the RS.
Have any of you fine people done anything similar? Would you be prepared to show me where you mounted it and how it looks?

Do you have a RAM mount on the bike now. I see they have a mount with a RAM ball.

5119Mg7bKqL._AC_UL320_.jpg - Bild entfernt (keine Rechte)

https://www.amazon.com/Quad-Lock-Ball-Ad...26193905&sr=8-8

No, at the moment, all I have is the Motorcycle Handlebar Mount:

https://www.amazon.co.uk/Quad-Lock-Motor...681304148&psc=1

I'd like to see if it's possible to fit that, to save having to buy other attachments, but not sure if it would work.

Post # 2 is a good and inexpensive option.

Zitat von wessie im Beitrag #3

---

if you want to fit a RAM ball to the bike then this part works well, replacing the one half of the clutch lever clamp

and here is the Qudlock part in the UK

---

if you have the regular RS bars a standard tube bar mount will actually work. Found that out in an emergency during a trip, where my phone tried to escape, watched it sliding down the road lol. A nice BMW salesman fitted a RAM mount for me.

The regular "U" will go around the lower bar of the two small bars. I have mine just left of the GPS, thats mounted directly to the center of the bars.

sorry dont have a pic and cant post links...

Hi Wessie,

I see you have it the opposite way around as well. Fair enough, if you have had it fitted for that amount of time without problems.

Zitat von wessie im Beitrag #7

---

It fits best instead of the inboard half of OE clamp. I have been using one for 5 years for my Zumo 390. It is very secure.

---

Hi Scorch, I used the following to mount a ram to my bars...
1x 2 x Spacers (10mm) - Motorcycle/Scooter
1x Motorcycle - Vibration Dampener
1 x Moto Mount Kit - All iPhone Devices - iPhone 12 Pro / Handlebar Mount[
It mounts on the lower of the stems no problem. I just rode 4k and I never even needed to tighten it.
This setup kind of lifts the phone so it sits a good viewing position and doesn't obstruct anything.

Zitat von GrantB im Beitrag #12

---

Hi Scorch, I used the following to mount a ram to my bars...
1x 2 x Spacers (10mm) - Motorcycle/Scooter
1x Motorcycle - Vibration Dampener
1 x Moto Mount Kit - All iPhone Devices - iPhone 12 Pro / Handlebar Mount[
It mounts on the lower of the stems no problem. I just rode 4k and I never even needed to tighten it.
This setup kind of lifts the phone so it sits a good viewing position and doesn't obstruct anything.

---

I cant seem to add photos!