Australia » How much was your run in service?

Hi
Just wondering how much you guys paid for your first service.
Just got it done and paid $300 and they didn't even wash the bike like they used to.
What's your experience?
Cheers

My recollection is that I paid $160 USD when I had my first service in June 2015. All they did was to change the oil and filter, reset the service warning, make sure nothing was falling off of the bike and check for computer updates.

Thanks for replying
Yes, that's basically what the first service is about.
Here in AU the service is quite good, however my last experience wasn't positive so wanted to know how much other people were paying, etc.
Cheers

Unfortunately I paid just over AUD $400. Can't see the value in it.

$380 from Bikebiz in Sydney.
Replaced engine oil & filter plus shaft drive oil.
Also had them check oil level indication as it was constantly showing 3 bars instead of ok or low. They have ordered a new oil pressure sensor, but since then have had random ok indications.
Also had them check a slight pinging noise when first on the throttle. Apparently reset some values, but still happening.

just had mine done for the 1250 in the UK and it was £169 not certain how that equates to your dollars

Graham

Zitat von midlife crisis im Beitrag #6

---

just had mine done for the 1250 in the UK and it was £169 not certain how that equates to your dollars

Graham

---

Well, just for the sake of comparison I paid $226 Australian dollars for the ~1000km service.

I must say I'm always happy when they don't wash my bike (in my vivid imagination it's a bored 16 year old directing high pressure water into every bearing seal).

I did my own oil and filter and FD oil change then took the bike to the dealer for the 600 mile service. $25.00 bucks for them to check it over and stamp the book. About 15 minutes.

GT

Mine was about £200 last April. They did wash the bike though.