Exhausts and Engine » R1200RS end can onto R1250RS

Does the R1200RS end can fit the R1250RS?
I still have my original end can from my R1200RS and was thinking of fitting it onto the R1250RS as it's not as big, is there any disadvantage in doing this?
Thanks

oh, your taking about the stock cans ..... You can always just try it if you have both there. Then you can educate us .....

Yes, it'll fit. I had a Remus 8 from a 1200 on my 1250RS. I did have to get a flapper cover from a 1200 though.

Zitat von Owdgit im Beitrag #1

---

I still have my original end can from my R1200RS and was thinking of fitting it onto the R1250RS as it's not as big,
Thanks

---

OK, thanks, I thought it looked smaller I've not got the bike home yet so can't measure them against each other.
Handy to know I'm not limited to the 1250 one and can use a 1200 one if one comes available and I will wait until I can source a used akrapovik or similar one.

I can tell you that Akra cans for the 1200 and 1250 are slightly different in size. The carbon fiber end piece is longer on the 1250. The 1250 version also has two exit holes where the 1200 has one. It must be due to the change from Euro4 to 5 compliance. I'm pretty certain that they would be interchangeable though. The mounting points and mid-section and CF flapper cover look the same.

Edit:- The Akrapovic weighs only about .5 Kg less than the stock can, so no real saving there.