General topics » Help please hex ez can

Hi all i have now taken ownership of a 21 plate r1250rs - i have a hex ez can from a previous bike and i want to fit this to my new steed - I’m struggling to find where i connect the ez can to the bike - i have read that you have to connect into the tyre pressure monitor system ?
1 is this correct ?
2 where is the tyre pressure monitor situated on the 21 plate r1250rs any pics would be a great help
Help would be great fully received , new to the 1250 so trying to find my way around - can’t get a manual anywhere

Regards john

Thanks

This might help, though it could be more obvious.

https://www.hexezcan.com/installation/r-series-lc/

If you want, DM me and I'll send you pics of my install. I have a 2020 so should be the same.

Hi, I have a 2020 as well, and the EzCan plugs in under the seat latch. The plug faces the rear, on the left/kickstand side of the bike.

The attached photo shows the EZcan plugged in on the 'top' and the PDM I have also in use, which I placed under the latch mechanism. Note, I flipped up the seat latch mechanism for my install, but you don't have to. just know what you see here is "under" the seat latch.