New Member Introductions » bar risers for r1250rs exclusive

Tried to fit bar risers on above bike today, all went well until I tried to fit the last 2 bolts closest to the tank But one of the holes was half a dia out of position with its corresponding hole, has any other members had this misfortune?????

I have Hornigs and didn't have a problem.

Did you try getting all 4 bolts threaded in loosely before torquing to spec? Did you make sure the bars were seated correctly?

Did you fully torque up the front two before doing the rear two? Or have you got left and right wrong way around?

My MV ones fitted perfect , I think fred on here had same ones

Wenn Sie hier auf Links zu eBay klicken und einen Kauf tätigen, kann dies dazu führen, dass diese Website eine Provision erhält.

I bought cheap Bar Risers from Ebay. They were a lousy fit and I had to grind a tiny bit away with a dremel. Also I wasn't happy with the supplied bolts. They looked pretty but the small head diameter meant I could look down in the counterbores and actually see the mounting hole on one side. Also they did feel undersized on the threads. I replaced them with some of a better quality and Nord-Lock washers. Not really a big problem to me personally, there would have been several riders out there riding with what I would call defective mounts.