Exhausts and Engine » Exhaust Header Nuts

R1200RS + R1250RS Forum � 1200 RS technology � Exhausts and Engine � Exhaust Header Nuts

Topic settings

Jump to forum

RS-Forum New Member Introductions Forum operation, design and help guest area My ride tour reports in planning training and coaching 1200 RS technology General topics Exhausts and Engine Tyres, Brakes and Suspension Tuning and modding Electronics Warranty stuff 1250 RS technology General topics Exhausts and Engine Tyres, Brakes and Suspension Tuning and modding Electronics Warranty stuff RS equipment Navigation accessories clothing and helmet What have you done to bike Knowledge Base Knowledge Base - how it works Knowledge Base Meeting Thread RS worldwide regions Africa Asia Australia Canada Europe Europe UK Middle East South America USA Midwest USA Northeast USA Southeast USA Southwest USA West RS Lounge Area Off Topic Other Bikes buy and sell forum rules

#1 | Exhaust Header Nuts datum

Sat Jan 23, 2021 2:44 pm

Hi Guys,

Does anyone know what type and size of socket I need to remove the two nuts that hold the exhaust header to the cylinder?
20210123_132802.jpg - Bild entfernt (keine Rechte)

Cheers
JayQ

reply

#2 | RE: Exhaust Header Nuts datum

Sat Jan 23, 2021 3:41 pm

You need a 12 sided socket. I'll check size...

13mm

I bought a cheapie set.

reply

#3 | RE: Exhaust Header Nuts datum

Sat Jan 23, 2021 5:17 pm

Ah ha, the socket set I normally use is 6 sided or side grip, I've just dug out my cheaper sockets, which are 12 sided, and yeap the 13mm fits, should have spotted that, cheers mate

JayQ

Sanemancured likes the post

reply

Polishing headers � � Anyone spotted any deals on Remus Ti cans anywhere?